Synchronous Valvehydraulic systemstructure

This machine consists of an electric motor, an oil pump, an overflow safety valve, an oil storage tank, and an air cooler device, which are connected by pipelines and electrical devices to form a whole. The structure and function of each part are described as follows:

（1） The system oil storage tank (8L) is welded and assembled from 32 # steel plate and corresponding angle steel, and an oil pan device is added above the hydraulic station. Hydraulic components are installed above the oil tank panel and can be connected to the load using quick change connectors;

（2） The overflow port of the fuel dispenser is installed above the panel of the hydraulic station and connected through pipelines to allow the hydraulic oil pump to pump out the work before returning to the oil tank.

（3） The hydraulic pump station is basically independently configured, with four positioning installation holes at the bottom and a filter screen inside the box. The upper oil level gauge on the front is used to observe the oil level, and the refueling height should be at 2/3 of the oil level gauge. If it is lower than 1/3 of the oil level gauge, refueling is required. The recommended cooling oil for work is 40 # and 60 # specialized engine oil, which should be determined according to the ambient temperature,.

Principle of synchronous valve hydraulic system:

The motor drives the oil pump to rotate, creating negative pressure in the suction area. The oil is sucked into the pump under atmospheric pressure and flows back to the oil tank through the overflow valve. The system pressure is regulated by the overflow valve. The motor starts, the overflow valve is in working condition, and the load can only be operated after confirming the connection with the quick change connector in advance. The motor is powered on, and the pressure at the hydraulic station's oil outlet and return pressure can be seen on the pressure gauge. In addition, this machine is equipped with multiple filtering devices, and the hydraulic oil will always be in a safe and clean state.

Technical requirements for synchronous valve hydraulic system:

1. Before assembly, all components need to be sorted and cleaned thoroughly

2. Assemble when conditions permit, and tighten all fasteners without any looseness during assembly.

3. The length can be customized according to specific customer needs or based on on-site craftsmanship.

4. Unqualified products must be strictly controlled and not assembled.

5. After assembly, the overall appearance is beautiful and clean.

label:hydraulic systemProduct Series

Related links:After sales maintenance

本文地址： http://www.shziying.com/product/product298.html