The anti glare panel overall mechanical performance testing machine is mainly used for testing the overall mechanical performance of plastic anti glare panels and fiberglass anti glare panels in terms of wind resistance load F and deformation resistance R.

Test method for anti glare board:

Wind resistant load: Fix the bottom of the anti glare board on the test platform, tighten the middle of the board with a special waveform fixture, use the center point of the fixture as the mechanical traction point, and use a rigid connecting medium to firmly connect with the traction part of the testing machine through a fixed pulley. The traction point should be on the same straight line as the lower edge of the fixed pulley, and the traction direction should be perpendicular to the surface of the anti glare board. When the connecting medium is completely relaxed, pull at a speed of 100mm/min until the anti glare board surface ruptures or reaches the maximum load, stop the test, and the maximum traction load received is the wind resistant load of the sample. Conduct three sets of experiments in this way, and take the arithmetic mean of the three test results as the test result.

Test method for resistance to deformation:

The experimental equipment is set up to withstand wind loadsFix the anti glare board on the testing platform and connect it well with the testing machineMark the projection from the top of the board to the plane of the control panelS₀Start the testing machine , in order to 15 mm/ minTraction at high speedWhen the traction load reaches the table 2 When subjected to wind resistant loads of corresponding specificationsStop pulling and remove the applied load Restore the free elasticity of the anti glare board ，5 mi nThe projection from the top of the post production board to the plane of the control panelShadow, marked as S₁, then the anti glare board has an anti deformation capacity RAvailable formulasrepresented as：R= （S₁ -S₀）／H

Applicable standards:

GB/T24718-2009 Anti glare board

GB/T1446-2005 Test Method for Properties of Fiber Reinforced Plastics

Main technical indicators:

1. Maximum test force: 50kN (30KN/20KN/10KN optional)

2. Test force measurement range: 0.4% -100%.

3. Accuracy of test force indication: better than ± 1% of indication

4. Test power resolution: 1/500000 (no grading throughout the entire process)

5. Measurement accuracy of beam displacement: resolution higher than 0.0025mm

6. Deformation measurement accuracy: ± 0.5% (within the range of 0.2-10mm)

7. Test speed range: 0.01-500mm/min, stepless speed regulation

8. Test space: A. Compression space: 700mm B. Effective width: 450mm

9. Whole machine power supply: two-phase, 220V ± 10%, 50Hz, power: 1.5kW

10. Working environment: Room temperature -35 ℃, relative humidity not exceeding 80%

11. Host size approximately: 1050 × 900 × 1900mm

12. Weight approximately: 600 kg