1TDL-40BLarge capacity centrifugePurpose:

TDL-40BLarge capacity centrifugeSuitable for qualitative analysis of serum, plasma, and urea in pharmaceutical products, blood stations, clinical trials, and biochemical laboratories.

IITDL-40BProduct Features

1. The casing is made of iron plate spray painted, with a built-in protective steel sleeve, simple and compact, lightweight in size, and low in noise;
2. Adopting advanced CPU control system, the microcontroller can more accurately control the speed, time, and relative centrifuge;
3. Stainless steel chamber, sturdy construction, suitable for continuous use.

IIITDL-40BProduct parameters

1. Model: TDL-40B

2. Speed: Starting~4000 revolutions per minute

3. Capacity: 6 * 50ml/8 * 50ml/4 * 100ml angle rotor

4. Centrifugal force: 2770xg

5. Power supply: 220V 50HZ

6. Timing range: 0-999min

7. Working hours: continuous

4TDL-40Binstructions

1. The worktable of the centrifuge should be flat and sturdy, and the workspace should be neat, clean, dry, and well ventilated.

2. Open the centrifuge lid and place the test tube for weighing *.

3. Close the centrifuge cover.

4. Press the "Start" button on the dial to start the operation.

5. Press the "time" button on the dial to set the time up and down.

6. Press the "Speed" button on the dial to set the rotational speed.

7. Before each shutdown, the speed must be set to zero; Timer reset to zero; Turn off the power switch again and unplug the plug from the socket.

8. Open the centrifuge cover, remove the sample, wipe the inner cavity and rotor clean, and close the centrifuge cover.

5TDL-40BMaintenance and upkeep

1. Do not place any substances on the centrifuge cover. After each use, be sure to clean the inner cavity and rotor.

2. If the centrifuge has not been used for a long time, the centrifuge cover should be opened for a period of time before use to dry the inner cavity.

3. The carbon brush of the motor should be replaced promptly after 3000 hours of use to avoid wear on the commutator.

4. The wear and tear of centrifuges after long-term use is a normal phenomenon.