Equipment featuresFeatures-Guangpu Guichuan-

High efficiency and good quality: The shell material is made of SUS304 stainless steel, or non-standard processing is carried out based on the user's choice of 316 stainless steel. The ultraviolet lamp adopts high-quality specialized ultraviolet lamps, with a long service life of the lamp tube and an output utilization rate of over 96%. Within the rated disinfection water volume range of the equipment. According to different water quality, the sterilization rate can reach 99% -99.99% at the corresponding dosage.

Stable and reliable: The equipment has a pressure resistance of 0.6MPa, a protection level of IP68, zero UV leakage, and is stable and reliable.

Strong applicability: The inlet and outlet adopt external thread, and can be processed with internal thread or flange according to user requirements. We can provide 185mm wavelength ultraviolet lamps for use in TOC removal ultraviolet equipment.

maintenancemaintenance-Guangpu Guichuan-

Regular cleaning of quartz casingFirst, turn off the power, remove the dust covers on both sides of the UV sterilizer, take out the lamp tube, remove the end caps, take out the "O" ring, and then slowly remove the quartz tube. When cleaning the casing, use alcohol as a cleaning solution. After cleaning, the operator should not directly touch the surface of the quartz tube with their hands to avoid dirtying and affecting transparency. Align the quartz tube with the water seal holes at both ends, insert the quartz tube with equal clearance at both ends, and insert the "O" - shaped rubber ring. Slowly and evenly tighten the pressure cap, without excessive force, to avoid causing the quartz tube to break. Then conduct a water test. If there is water leakage, gently tighten the pressure cap until there is no water leakage. Finally, install the lamp tube and start running.

instructionsDescription-Guangpu Guichuan-

The ultraviolet sterilizer of this device is horizontally installed indoors, with the bracket fixed on a designated foundation or workbench. (Connect the inlet and outlet) The sterilization device is located indoors. In addition to considering the convenience of water supply and drainage and meeting the requirements of the process flow, attention should also be paid to leaving an installation position where the ultraviolet lamp tube and space can be extracted. The electrical control box is installed near the device, with a relative humidity of no more than 80 ℃, no corrosive gases, no conductive dust, and no strong vibration and impact.

This product is a pipeline type ultraviolet sterilizer, with two water outlets that can be selected as the inlet and outlet according to the pipeline direction. It can be placed horizontally or vertically according to user needs. To facilitate the replacement of light tubes and quartz tubes, there should be space of the same length on one side as the equipment.

After product installation, conduct a water test to ensure no water leakage, and then connect the power supply.

After connecting the power supply, the indicator light will turn on to ensure that the lamp head and lamp tube are connected properly. Then, press the "power switch" button on the dust cover and the lamp tube indicator light will turn on. The timer will rotate and wait for 3-5 seconds for the lamp tube to light up. At this time, the equipment will operate normally. After confirming that the lamp tube is on for 3-5 minutes, first open the water valve, and then open the water inlet valve. At this point, the machine will start running.

Installation sizeinstallation-Guangpu Guichuan-

The installation of ultraviolet sterilization and disinfection equipment usually follows the principle of left in and right out by connecting the inlet and outlet flanges, turning on the power, and pressing the switch button to work normally. The inlet and outlet can be flexibly installed according to the on-site working conditions. The installation diagram is as follows:

Guangxi Guangpu has been specializing in the production of high-quality ultraviolet disinfection equipment for many years, and has complete qualifications such as water related permits, inspection reports, and product patent certificates,China Construction Eighth Engineering Division, South China City, Wanda, Evergrande and other units are also using our company's ultraviolet disinfection equipment,The product quality is trustworthy, the service is thoughtful, and a free disinfection plan is designed.
Welcome friends from all over the country to call and inquire: 13978628029 (Qiu Gong)